Installation Methods for table/floor lamps

 

1. Preparation

1) At first, please read the instruction for installation, check the type of lighting fixtures, confirm the quantity, at the same time, prepare the tool bag, that includes flat or cross screw driver, hammer, etc.

 

2) Tear off the bag, do not change the position of the display at will, and set the last used part aside according to the prompts to save time in finding parts during installation.

 

2. Installations

1) In general, it has iron base, that is smaller than surface base, the black platic hat is used to fix the shade. The order from the bottom to the top is the chassis fastening nut, cast iron chassis, base, lamp post, lamp cap, lampshade, plastic fasteners, bulbs, etc. Please be careful for the order.

 

2.) The power cord from the table/floor lamp pole is to pass through the chassis fastening nut, cast iron chassis and base, then we could connect it to the power line, at last, then wrap it in electrical tape, The chassis should have a recessed position to extend the power cord.

 

3) The power cord of the table/floor lamp must be handled well, pay attention to the safety of use, because the indoors move around and avoid the falling over by the wires.

 

3. Check

1) After finishing the installation of table/floor lamps, we could compare it with installation diagram, and check the confrim problem of screws.

 

2) We could let the table/floor lamp power on, and check the switches, then check whether it works or not, if does, we could keep it turned on for 10 minutes to check the problem.