1. Choose proper position, take out the brass gasket and keep it closed to the wall, then mark the installation hole by the pen.

2. Use 6mm drill bit to drill hole and install.

3.Inset the expansion bolt into the hole.

4. Wall, pitch hole of product Use the screwdriver to fix the brass gasket.

5. Use the ruler to measure the pitch hole of toilet paper holder.

6. Place the gasket position according to pitch hole, then mark it by pen in the same horizon line.

7. Use 6mm drill bit to install the second gasket in the same horizon line.

8. Fix the toilet paper holder to the wall closely according to the gasket position.

9. Use hexagon wrench to fix the bottom screw.

Toilet paper length ≤ 13cm ( 5.1"), Diameter ≤ 13cm ( 5.1");

* In general the installation height can be around 26 inches (66 cm).