Installation Instructions

TYPE ONE

1.First step, take measurement, mark the horizontal point according to the grab bar height.
2.Second step, adjust the installation position according to horizontal points, we could punch and mark the hole.
3.Third step, drill the hole in the mark position and insert the expanding plug, in general, we could use 8mm bit.
4.Fourth step, insert the screw and fix the grab bar.
5.Fifth step, put the blind flange on the flange.
6.Installation complete

TYPE TWO

1.Confirm the installation height according to the users.
2.After confirming the height, to mark the drill position.
3.Drill holes(watering the bit when drilling)
4.Insert the expansion screw into the hole.
5.Screw into the bolt on the base.
6.After finishing installation, to cover the decorative cap.