1.you should take out the faucet first, and then check all the fittings to find out that whether they are all in good conditions: 2 rubber gaskets, 1 threaded joint, 1 sleeve piece, and 2 water hoses. Before the installation, please remember to remove dirt from the installation hole and the water supply pipeline to ensure that there is no debris in the water pipeline. In order to protect the faucet from scratching, you can install the faucets with soft gloves.

2.you can take out the plastic washer. The washer is used to alleviate the pressure of the metal surface of the faucet and the ceramic basin. Then you can insert a water inlet pipe into it and screw it.

3.put the thread into the first water hose, and then put second water inlet hose through the threaded joint.

4.in this step, you should screw the second inlet hose into the inlet port. Please pay attention to the correct direction, and then tighten the threaded joint with force.

5.put the two water hoses through the white mat.

6.you can install the locking nut in this step and fix the faucet.

Warm prompt: when you meet any problems during the process of installation, please contact our customer service, and we will give you a detailed answer.

7.tighten the sleeve piece.

8.lock the two water inlet pipes and valve interface. Do not use pliers to twist it with force to prevent deformation or break. Pay attention to the connection of cold and hot water.